Aeromodelling Workshop – 2nd October 2017

The second edition of our in-house Aeromodelling workshop is going to start on 2nd October 2017. Unlike last workshop, which was a 2 day (9am-5pm), this one is going to span 6 days and timing will be 4.30pm to 6.00pm. Continuous 2 days is taxing not only for me but also the students. The whole point here is to enjoy the workshop and not be in a race to finish something.

The fuselage will be built using coroplast and/or biofoam. Wing will be built from high density thermocole using hot wire cutting process.

Model specifications:

Wingspan – 1250mm
Fuselage – 895mm
Wing type – Tip Dihedral
No. of channels – 3
Model AUW – 750-850gms

Please note:

  • Electronics is not included in the training package and can be purchased on site if required.
  • All models will be fitted with spare electronics and will be tested for flight worthiness at a convenient flying location at a later date.

Some photos from our last workshop (2 from the workshop are already flying regularly with us and one of them has built several models too)

Aeromodelling Workshop - May 2017 Aeromodelling Workshop - May 2017 Aeromodelling Workshop - May 2017 Aeromodelling Workshop - May 2017 Aeromodelling Workshop - May 2017 Aeromodelling Workshop - May 2017 Aeromodelling Workshop - May 2017 Aeromodelling Workshop - May 2017 Aeromodelling Workshop - May 2017 Aeromodelling Workshop - May 2017

Leave a Reply

Your email address will not be published. Required fields are marked *